Induction Heater,12-48V 2500W ZVS High Frequency Induction Heater Module wirh Coil,Heating PCB Board Module Flyback Driver Heaters,Heat-Induction Tool for Quenching,Annealing

Package IncludedYou will receive 1pc Induction Heater (Black; Size: about 120x240x85mm/ 4.72 x 9.45 x 3.35 inch; Power requirements: less than 12 V greater than equal 10A 15 V or more greater than equal 20A); and 1pc x Copper Ring. | NotesDue to the excessive power and heat generated by the device, please take good measures to dissipate heat and avoid heating too much metal, otherwise it may cause the device to overload; This product requires a self-contained power supply (recommended to use a 36V 20A power supply). | Induction Heater Module PCB BoardThe heating plate is made of grade PCB, and the performance is stable. (Maximum power: 2500 W; Maximum current: 50A; Input voltage: 12V-48V recommended above 36 V). | Induction Heater ModuleUsing six IRFP260s and 12 parallel resonance capacitors, the power is high and the efficiency is high. The output terminal uses three copper columns in parallel, which can be connected to other outputs such as high-voltage packet. The power line is completely covered with copper cover design, which can increase the current and heat generation. Using large and large power supply of the heat sink to dissipate heat better. | Wide ApplicationThis induction heater can use be used by DIY players to quench, anneal and other treatments for small parts, and can also be used with graphite crucibles to melts metals such as gold, silver, copper, aluminum, etc.